Jetcat P80 Manual
Turbine JetCat P-80 SE Introducing the new JetCat P80-SE with more POWER and enhanced reliability. The P80-SE continues our extreemly successfull P80 engine. The new design of the P80-SE incorporates an optimized compressor/diffusor-system, resulting in higher engine performance and reliability. The engine follows throttle commands almost without delay. In addition to the outstanding features of or ECU V6.0, the new ECU V6.3 has an „auto power down“ function built in, which allows to switch off the engine power supply (- receiver off) before the engine cool down sequence has been finished. In this case the ECU will stay powered on, finish the cool down sequence and then auto power down itself. JetCat P-80-SE turbine complete with starter includes:.
Jet-tronic ECU (fuel control electronics). GSU (Display and Programmer). LED I/O board. Miniature fuel pump. Electronic starting gas valve.
Electronic Fuel valve. Fuel tubing, tubing connector set, filters, and cable set. 2 cell, 2500mA LiPoly battery pack. Starting gas tank. Turbine mounting clamp, RamTec compatible. Detailed instruction manual. Thrust: 22 LB @ 125,000 RPM.
It will help you understand, care for, and lower the repair and maintenance cost for your New Holland tractor. This New Holland LX465 Skid Steer Loader Service Manual is the same service manual used by professional New Holland technicians. Every New Holland tractor service manual is indexed and fully searchable. This New Holland repair manual contains all you need to know to keep your New Holland working right and is the only service repair manual you will need. All pages are printable, so its easy to print what you need and take it with you into the garage or workshop. New holland 465 skid steer.
Jetcat P80 Turbine Engine
Weight: 2.9 LB, incl. Starter. Diameter: 4.4 inches.
Jetcat P80 R/c Turbine Engine
Dakine did they send you the HP5 Manual or the standard jetcat P80,70,120,160 manual. The last time i talked to Bob Wilcox i was told that there was no HP5.
RPM Range: 35,000 - 125,000. Exhaust gas temp.: 580°C -690°C. Fuel consumption: 9 oz per/min at full power. Fuel: Jet A1, 1-K kerosene.
Lubrication: approximately 5% synthetic turbine oil in the fuel. Maintenance interval: 25 hours.